I am using a friends LFOtool in Bitwig and there are two issues.
1: It seems midi notes stop at LFOtool and are not being passed through. This is causing some issues in some specific routing I am wanting to achieve. As an example, I would like to use LFOtool in my Note FX container so that I can modulate the instrument LFOtool is nested inside of.
Is there a way to get midi to pass through LFOtool?
2: When using MIDI CC out inside of Bitwig it seems the bottom of the LFO is not the same as a value of zero in midi. It seems the signal is coming out Unipolar and the bottom and top of the range are two rows up and two rows down respectively. This limits the seems to limit the resolution I can draw at and limits my ability to draw custom LFO's that are using midicc to control over devices.
Is there a way I can use the Whole OR Bottom or Top Half of the MSEG to draw my LFO and output a Unipolar?
Is there a way I can use the Whole MSEG window to draw a Bipolar LFO that would output a Bipolar signal via MIDI CC?
P.S. I feel like solving these would make LFOtool completely usable in almost every situation I can think of as an MSEG for my DAW of choice, Bitwig :)
